This cardboard isn't protecting anything! |
1) Ruined Cardboard
Avoid bent cardboard when sending cards. Cardboard is supposed to prevent the card from being bent, not bend with the card.
In what I have observed, some postal workers are not gentle with mail, and the written warning "do not bend" does not curb this phenomenon. Only effective shipping - and thus firm protection - does.
2) Sleeves without Tape
I normally do not advocate for tape on the top of sleeves; as a buyer I find tape on sleeves unnecessary (because the toploader should be taped). Depending on how much tape, it can also be tedious for a buyer to remove heaps of tape from sleeves.
However, it is necessary to tape the top of the sleeve when shipping with cardboard. This is because the possibility of the card slipping out arises. As discussed before, sending cards without protection is a recipe for disaster.
3) Cardboard as a Replacement for other Protection
Some sellers choose to sandwich a Pokemon card without a
sleeve between two pieces of cardboard and apply tape of each of the sides.
However, this method leaves potential for other problems, no matter how well
the pieces of cardboard are taped.
Most importantly, the card is likely to rub against the tape
during shipment. While it may seem excessive to worry about a card rubbing
against tape, for more serious collectors, pristine condition means pristine,
and even the slightest flaw might warrant a refund.
Tell me these cards will stay in place the entire time. |
Regular scotch tape sticks, but can easily slip loose. If a
card manages to get out of the cardboard protection, the postal service will
wreak havoc upon it.
This form of lazy shipping is especially problematic for
shipping of multiple cards. It is even easier for cards to get scuffed when
there are many, because when there are more cards, more tape must be used to
secure the cardboard. Even when the sandwiched cards are sleeved, I would not
recommend putting more than five between the cardboard pieces.
4) Small Cardboard
When the cardboard is too short, packagers find themselves bending the sleeve - and card - so the side of the sleeve coincides with the side of the cardboard. If this is done without care, these packagers could find themselves accidentally bending the card trying to protect it. I would recommend having the cardboard at least a quarter of an inch extra long on all sides, though I prefer an extra inch on the bottom and top, as seen in the picture for the third tip.
Always remember when shipping, safe is better than sorry. It is better to use an extra piece of tape and not risk giving a refund for damaged cards. And with that you should be good to ship Pokemon cards using cardboard.
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.